![]() |
![]() |
2.4GHz Long Range Video Transmitter and Receiver
This compact long range wireless video transmitter enables you to send video and audio from one location to another without expensive and messy wiring. It works with all types of AV devices including video camera (NTSC/PAL), TV, recorder and so forth. This high performance transmitter outperforms other transmitters in the market with these:
Use compact AV transmitter module with high output power (3W, 8W and 10W and 15W)
Use high reliability/linearity/AIGaAs/GaAs FET amplifier module
Adopt phase locked loop circuit to eliminate frequency drift
Also available in 1.2GHz and 900MHz frequency bands.
Transmitter (on the right in picture below): Input jacks of video and audio for AV device such as video camera, TV....
Receiver (on the left in picture below): Output jacks of video and audio to a display/recording device such as TV, recorder, computer....
Transmission range: Range may vary substantially depending on the actual operating environment. Range up to 1,000 feet (300 meters) in open space with high gain omni-directional antennas of 12dBi or higher. Longer distance can be achieved if high gain directional antennas are installed in a line of sight environment. (NOTE: High gain directional antennas are mandatory if long transmission distance is anticipated)
Maximum transmission distance in an unobstructed environment between two static points using 12dBi high gain directional antennas on both sides**
3W Model (35dBm) 7 miles (11 km)
8W Model (39dBm) 15 miles (24 km)
10W Model (40dBm) 40 miles (64 km)
15W Model (42dBm) 45 miles (72 km)
**For reference only. For long distance transmission, at least 60% of Fresnel Zone clearance should be observed.
Sample applications:
Send video wirelessly from a surveillance camera to TV, monitor, computer, recorder.
Send video wirelessly from the surveillance cam at the main gate back to the house.
Send video wirelessly to the opposite building.
Send video wirelessly between two mountains.
Send video from an outlying island back to the seashore.
Easy installation. Setup can be completed within minutes.
4-channel 2.4GHz AV transmitter. A 7dBi omni-directional antenna is included for 3W model only.
4-channel 2.4GHz AV receiver with a 7dBi omni-directional antenna.
Two 12V universal regulated power supplies.
Two BNC-M to RCA-F adapters (if you need BNC-M to RCA-M, please select when ordering) and
One RCA AV cable for the receiver.
For specifications of 15W model, please click here.
Profile |
Receiver |
Transmitter |
AV demodulation/modulation | FM | |
AV output/input | RCA(F) output jacks for video and audio | BNC(F) input jacks for video and audio (BNC to RCA adapters included) |
Number of Channel | 4 channels - select by sliding switch | 4 channels - set by sliding switch (inside) |
Antenna included | 7dBi omni-directional antenna | 3W:
7dBi omni-directional antenna included. 8W, 10W and 15W: no antenna included. (see Note 2 below) |
Antenna length/weight | 19.8 cm (7¾") foldable / 24 gm | 3W Model only: 19.8 cm (7¾") foldable / 24 gm |
Antenna connector type | SMA (F) | 3W: SMA(F); 8W, 10W & 15W: N(F) |
Operating power | DC 12V (100~240V regulated power supply included) | |
Dimensions | 115(L) x 80(W) x 20(H) mm | 144(L) x 115(W) x 53(H) mm, except 15W model |
Weight | 125 gm | 660 gm, except 15W model |
Video output/input | 75 Ohm 1V p-p | |
Audio output/input | 10k Ohm 2V p-p max. | 2V p-p, max |
Power voltage/consumption | DC12V 0.5 A |
DC12V 3W: 1.2A; 8W/10W: 2.5~3A; 15W: 4~5A |
Power connector type | DC jack for 5.5 mm plug | |
Sensitivity/Output power | Sensitivity: -90 dBm | Output power: 3W, 8W, 10W or 15W |
Audio sub carrier frequency | 5.5 MHz | |
Impedance | 50 Ω | |
Preset channel frequencies <in MHz> | Channel 1: 2413, Channel 2: 2432, Channel 3: 2451, Channel 4: 2470 | |
Highest resolution supported | NTSC: 768(H) x 494(V) / PAL: 752(H) x 582(V) | |
Operating temp/RH | -10~+50°C / 20~80% |
If the transmission path is a line of sight environment, the transmission/reception will be significantly improved by using Yagi directional antennas, panel antennas or other high gain antennas.
For 8W, 10W and 15W transmitters, it is recommended to use antenna of at least 9dBi gain or above.
If it is necessary to use antenna extension cable, the cable should be kept as short as possible because, the signal attenuates directly proportional to the length of the cable, i.e. the longer the cable, the weaker the signal from the antenna. Alternatively, you may extend the distance between the transmitter/camera or the receiver/monitor or recorder by using regular video cable.
The transmitter housing will become hot after powering on for some time because heat generated inside will dissipate through the aluminum housing.
** UPS delivery option is not available for these antennas except panel antenna.
Home | What's New | Products | FAQs | Resources | Terms of Sale | Disclaimer | Contact Us
Copyright © 2002-2012 VFM Store. All Rights Reserved.