Range Extender Antenna: 2.4GHz MIMO Panel Antenna


A MIMO antenna is one in which two or more antennas are integrated inside a single enclosure. In conventional wireless transmission, a single antenna is used at the transmitter side and another one at the receiver side. In many cases, this give rise to problems of multipath effects. When an electromagnetic field is met with obstructions such as hills, buildings, trees and so forth, the wavefronts are scattered and thus they take many paths to reach the destination (the receiver). The late arrival of scattered portions of the signal causes problems such as fading, cut-out and intermittent reception. In digital communication systems, it would cause a reduction in data speed and an increase in the number of errors.

By using MIMO antennas at the receiver side and/or the transmitter side, in case of digital transmitter, this will limit the degradation caused by multipath wave propagation. These additional paths can even be used to advantage because they can be effectively used as additional "channels" to carry data, therefore increasing the link data capacity. Accordingly, this antenna is particularly useful for areas susceptible to multipath interference.

The antenna is weatherproof and is therefore suitable for indoor as well as outdoor installation. The casing and connector are made of corrosion-resistant material to withstand harsh outdoor conditions. Suitable to use with receiver and/or digital transmitter to improve gain for better coverage. 5.8GHz version is also available.

Packing Contents:

1) A panel antenna with 3 or 4 built-in antennas; and
2) An U-bolt pole-mount kit for easy alignment at different degrees in up/down tilt positions

NOTE: You may need to connect the antenna to the receiver/transmitter via an antenna extension cable (option item).

Model ANTM243 / ANTM244
Product Description MIMO directional panel antenna
Peak gain 14 dBi each (3X or 4X)
Frequency range 2400~2500 MHz
Impedance 50 Ω
Polarization vertical/horizontal
Horizontal beamwidth 120°
Vertical beamwidth 17°
Max. input power 100W
VSWR ≤ 1.5:1 (avg.)
Number of output port 3 or 4 depending on antenna model. Connector type of all input/output ports is N-F.
Radiating element material low loss solid brass
Radome material ABS plastic
Mounting kit pole mounting kit included
Lightning protection direct ground
Application for AV receiver or transmitter
Dimensions (H x W x D) 30 x 30 x 2.6 cm (11.8" x 11.8" x 1")
Weight 1.2 kg (2.6 lb)
Working temperature -40 ~ 60° C


1)    When running extension cable between the antenna and the transmitter (or the receiver), it should be kept as short as possible. It is not recommended to run cable beyond 10 meters (approx. 32 feet) to avoid excessive signal loss.

2)    Instead of using extension cable between the antenna/transmitter (or the antenna/receiver), you may extend the distance between the transmitter and the camera (or the receiver and the monitor) using high grade 75 ohm coaxial video cable such as RG6 cable. See an illustration here.

3)    Directional antenna can be used in combination with omni-directional antenna.

Understanding the environmental sources affecting signal transmission


RF Splitter

Add an extension cable for the antenna(s) ordered?


This is a SSL secured site for online shopping

Pay securely with major credit card